What is the "Water O3zonator"?

[파이랑]

What is the "Water O3zonator"?

The Water O3zonator Model# WOZ4 is a  true* 200mg/Hr Corona Discharge (CD) Ozone (O3) Generator used for Water Ozonation &Oxygenation that is powered by 12 Volts DC. Ozone has powerful oxidation potential and is used to disinfect, sterilize and oxygenate water. (Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.)

NOTE: The Ozone generated by the Water O3zonator is NOT intended to be breathed in! It is intended for water ozonation only. Ozone can be very damaging (through rapid and powerful oxidation) to sensitive lung tissues. Always use the Water O3zonator in a well ventilated area. A stove-top exhaust fan works well to remove the off gas of the Water O3zonator unit.

NOTE:The WOZ4 unit's output ozone concentration is below permissible levels (<0.05 PPM) at a distance greater than 48" from unit.

NOTE: Exposure levels of Ozone in air at 0.1 ppm can be tolerated for up to 8 hours before being considered a hazard. With the WOZ4, the Ozone reading in the air is 0.1 ppm and less, 24” from the source. At 48” from the source, the reading is 0.06 ppm and less.

NOTE: The WOZ4 unit is not a medical grade ozone generator. Medical grade ozonators usually cost 5-10 times more than even excellent quality, non-medical ozonators like the WOZ4. Because our model WOZ4 ozonator does not incorporate medical grade components, it is recommended that you do not attempt to feed pure oxygen (O2) into the chamber. This caution applies to any ozone generator on the market that does not have medical grade parts and components throughout. 

Representing a significant advancement in ozone generation design, our unit is a next generation ozonator.

The Water O3zonator Model WOZ4 is a highly efficient,

Fused Quartz Crystal, High Frequency Corona Discharge (CD) ozone generator utilizing inventor-genius Nicola Tesla's principles. Breakthrough technology has been applied to the WOZ4 allowing it to operate from a 12 Volt DC power source like an automobile battery or appropriate solar panel. The WOZ4 unit is complete with a built-in Air Pump.

The WOZ4 outputs a true 200mg/Hr. (Measured with a GM Anceros ozone-in-air analyzer).

Ozone concentration is a maximum of 2.9 Gamma (ug/ml or mg/l) at 0.5 LPM flowrate. The WOZ4 can ozonate an 8 ounce (250mL) glass of room temperature water in less than 1 minute and achieve an ORP (Oxidation-Reduction Potential) of over an outstanding +1,000mV ORP in less than 3 minutes). Water sterilization occurs at greater than 600mV ORP, thus the WOZ4 exceeds the requirements for water sterilization.

Click the image to the left for an enlarged picture of an independent FDA recognized laboratory analysis of our previous 108mg/Hr WOZ3 unit against E.Coli (Escherichia coli ATCC 8739 [ESC]), Staph. (Staphylococcus aureus ATCC 6538 [SAU]), and Pseudomonas (Pseudomonas aeruginosa ATCC 9027 [PAS]) Using advanced principles of the 1900's inventor-genius Nicola Tesla, our manufacturer has designed an exclusive, state-of-the-art ozone (O3) generation unit that incorporates a new and proprietary approach to ozone generation: Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS). This results in the WOZ4 requiring less than 1.2 Amps current at 12 Volts DC to operate both the Ozone Generator and the built-in Air Pump, allowing for quiet and reliable operation.

The Water O3zonator uses state-of-the-art electronics and a unique circuit design allowing the unit to be extremely lightweight, portable, powerful, efficient and able to run off a 12 Volt DC power source like an automobile battery if needed.

The Water O3zonator unit takes less than 2 minutes to achieve maximum Oxidation Reduction Potential (ORP in mV) in an 8 ounce glass (250 ml) of chilled and purified water to +1,000mV ORP. For 32 ounces (1 Litre), expect full ORP in less than 10 minutes (see graph below).

For a technical explanation of Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS) click the links.

Click the image above to see the internal components of the WOZ4.

Unique Features

• O3 rating: True* 200mg/Hr @ 2.0 LPM output (*Measured with a GM Anceros ozone-in-air analyzer. Many manufacturers measure ozone output with the chemical titration method, which gives an incorrectly high reading. Our WOZ3 would be rated at over 200mg/Hr with this test method.)

• O3 concentration: 2.9 Gamma (ug/ml or mg/l) @ 0.5 LPM

• Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.

• Ozone Tube uses high-grade type 214 Fused Quartz Crystal (99.995% pure quartz crystal)

• High Frequency Corona Discharge (CD) design for quiet, efficient operation

• Built-in Air Pump rated 0.5PSI @ 2.0 LPM

• Super-lightweight and portable design: Weighs only 3 Lbs (1.3 kgs)

• Simple operation. Turn the unit on and it's ready to operate.

• 12 Volts DC @ 1.2 Amps. (Comes with an AC-DC Wall Adapter rated at 12 Volts DC @ 1.5 Amps)

• Utilizes SOTA's proprietary (inventor-genius Nicola Tesla based) Dynamic Resonant Mode Operation (DRMO) and Zero-Point Voltage Switching (ZPVS) for extremely efficient and reliable operation

• Aluminum-free. Absolutely NO aluminum or ceramic alumina (aluminum oxide) used in the ozone path.

• Ceramic Air Stone: featuring a 90 micron pore diameter, extremely durable, long lasting, inert and non-toxic, high performance air bubbles. Inlet pipette is made of Kynar, a highly ozone resistant material used in medical grade ozonators.

• Silicone Air Tubing: will never harden, crack or kink.

• Maximum ORP (mV) Saturation: <5 minutes per 8 ounces (250 ml) chilled  and purified water

• +1,000mV ORP <20 minutes for 32 ounces (1 Litre).

Compare the saturation of Ozone in Chilled Water shown above, and with Room Temperature water shown below:

The Complete Water Ozonator Unit

Click on image to enlarge it

Electronics

Our Corona Discharge (CD) Ozone Generator uses proprietary state-of-the-art electronics allowing for great efficiency,

 super-lightweight design, and powerful output.

Specifications

• Ozone (O3) Output: True* 200mg/Hr Ozone (O3) production at 2.0 LPM

• O3 Concentration: 2.9 Gamma (ug/ml or mg/l) at 0.5 LPM

• Independent Lab Test shows virtually zero Oxides of Nitrogen (NOx) in output.

• Powered by 12 Volts DC @ 1.2 Amp.

• Air Pump: Built-in to WOZ3 unit outputs 0.5 PSI @ 2,000 cc (2 LPM)

• Maximum ORP (mV) Saturation: <5 minutes per 8 ounces (250 ml) chilled and purified reaches over +1,000mV ORP <20 minutes for 32 ounces (1 Litre).

Dimensions

• Water O3zonator:  7.9" Wide x 6.25" Deep x 2.5" High (20cm Wide x 16cm Deep x 6.5cm High). Casing is high-impact ABS plastic. PC-Bone Colour. Weight 3 Lbs (1.3 kgs).

Each Water Ozonator comes complete with:

• The Water O3zonator WOZ4 unit (200mg/Hr Corona Discharge (CD) Ozone Generator w/ Built-in Air Pump)

• Operating Instructions

• Ceramic Air Stone

• 4 Feet total of Silicone Air Tubing

• Our WOZ ships with an International Wall Adapter intended for any voltage from110VAC 60 Hz (North America) to 220/240 Volt AC 50 Hz Mains (as found in International Countries). With it you can use your new WOZ3 virtually anywhere in the world. The AC-DC Wall Adaptor is rated at 12 Volts DC @ 1.5 Amps, centre positive. (NOTE: This wall adapter can be used on The Silver Pulser, The Silver Maker, or The Magnetic Pulser .)

International Voltage (220/240 Volt AC 50Hz Mains)

Requirements

• Our WOZ4 ships with an International Wall Adapter intended for any voltage from110VAC 60 Hz (North America) to 220/240 Volt AC 50 Hz Mains (as found in International Countries). With it you can use your new WOZ4 virtually anywhere in the world.

• Additionally, the Water Ozonator may also be operated directly from a 12 Volt DC Battery like an automobile cigarette lighter. You will need to purchase an adapter cord which plugs into the cigarette lighter and has a Centre Positive, 2.1mm Plug, like from Radio Shack?.

Options for Powering the Water O3zonator

In the event of a power outage here are some options for powering the Water Ozonator: