삼성 매직스테이션 CD-ROM Driver_For DosOS

[운영자]

            **********************************************
            *  README  For SAMSUNG CD-ROM Drives       *
            *                  May   1996                *
            **********************************************
                 (c) Copyright SAMSUNG Electronics , 1996

 ====================================
    Tips on using MSCDEX.EXE switch
 ====================================

   1. [ /M:10 ]
      It is the added switch in AUTOEXEC.BAT when running CDSETUP.EXE.
      ( Not specified in the user's manual)

 ===========================================
   Tips on using SSCDROM.SYS switches
      ( Not specified in the user's manual)
 ===========================================

   1. [ /S:xxx,yy,z ]
      Specifies the IDE port that is connected to the drive, and the interrupt request.
      Where 
       * xxx is the IDE port address
             xxx = 1f0 : Primary (Channel 1)
            170 : Secondary(Channel 2)
                   1e8 : Channel 3
                   168 : Channel 4

       * yy  is the Interrupt channel.
             yy  = 14 : Primary (Channel 1)
                   15 : Secondary (Channel 2)
                   11 : Channel 3
                   10 : Channel 4   
   
       * z is the Master/Slave selection.
              z =  0 : Master
                   1 : Slave

       Note: If /s:xxx,yy,zz is valid,the device driver will only test that
      specific IDE port, and skip the auto-detection. If the /s switch is
             not used or if any parameter is invalid, the device driver will still use
      auto-detection algorithm.   

       For example, when the CD-ROM drive is connected to the secondary port using
 interrupt 15 as slave, the syntax in the CONFIG.SYS file should be as follows:
   
      Device = C:\SAMSUNG\SSCDROM.SYS /D:SSCD000 /S:170,15,1 /V 

 
   2. [ /V ]
      Displays CD-ROM Drive Model Name.
   
   3. [PIO]
    
      Fast PIO modes support

      Use /PIO for PIO modes support.  If /PIO is used, the driver will
      check the drive's PIO capability, then use the highest PIO mode. 


MSCDEX.EXE

README.DOC

SSCDROM.SYS