MRX 5R 출시 예정,,,,,,,,,,,

[함창우(68)]

 MRX5R ,,,

-----------------

☆ Wire type front anti-roll bar. As a result of this change, I change specification Front lower arm, front bulkhead,

    as well as front upper bulkhead L / R. Φ2.3 mm comes in a kit standard front anti-roll bar.

☆ By changing the shape of the plate, side belt tensioner to adjust the tension of the belt in two places

    tensioner bearing.

☆ Clutch system changes to type H2707, acceleration from low speed range will be smooth.

    (1st. gear: 16T/2nd:. Gear 20T)

☆ Main chassis is high traction chassis with excellent traction and steering and (Mugenlogo sculpture).

☆ By changing the shape of the front body mount plate, mounting holes in the body post has been added.

☆ Rear lower arm mount A & B has been enhanced.


--------------------

◆ bulkhead of the rear and front becomes out machined aluminum, maintenance work can be easily done, such as 

    a belt replacement.

◆ By replace upright upper plate of three (optional), front upright, you can change the kingpin angle.

◆ Is attached to the RC module, servo throttle and steering fits the case of the RC receiver modules.

◆ Brake disc, so that is attached to the rear axle solid, braking is applied to the rear drive shaft directly.

◆ 2 inserts at the top and bottom, mounting location of the front upper arm suspension shaft can be changed

    geometry of changing the end of Bush that there are two types of rear suspension shaft.

◆ By changing the mounting position of the steering servo saver arm, the hole location of the front upright arm, 

    you can change the Ackerman.

◆ Mounted directly next to the pulley and machined aluminum, lightweight middle shaft.

◆ 2 speed shaft, two speed unit is mounted in the hollow shaft of φ8mm. (1st. gear: 49T/2nd gear:. 46T)

◆ The rear body mount, hard type to improve the rear grip is attached.

◆ There are four options in the configuration, weights, you can adjust weight, and balance.