What's Uppp!!
James Motors is finally putting together our 2013 Electra Gide 26" Custom Bagger.
We know you have been waiting a while for this and so have we.
Lets get started on this bagger !!
Work on the holes for the hydraulic clutch and
brake line builder kit are under go.
We got the lining clean and all inside the handle bars.
On the holes we fit a small rubber seal so the line does not get messed up.
After a quick inspection...
We get parts that are hard to reach cleaned up before the parts go on.
Thanks to Metal Sports for the fabulous "Imperial" wheel.
Azzkikr's shiny fork cans & Dirty Bird's wrap fender.
Just to let you know
The "Shark" bike is a made from Azzkikr's body parts.
Only except for the Wheel / Front Fender / Hydraulic Clutch.
As seen in the picture the parts are slowly coming together.
Muffler / Point Cover / Brake Pedals / Shift Pegs / Derby Cover
ETC...
After the inner fairing got assembled the guys got started
on the breeding and wire routing.
As you guys can see ... to prevent any damage to the paint job we
taped up the main body parts.
After the wires and breeding finally the outer fairing is also
put together.
The digital gauge looks badass with this paint job and bike !!
After the work on the fairing is finished we get the
handle bar in place and bring it down from the lift.
The front of the bike looks nice !
The chrome grill in front gives the bike attitude!!
This bike is a bit different from other Road Glides.
For starters we the key box is located on the side.
If you look closely you can see that the key box is where the horn usually is.
Anyways we have to get ready for an event at the Hannam Harley Davidson !!
After getting our bikes cleaned up we get ready to head out for the Street 750 Launching Party !!
7 of Our James Motor's bikes and our F-150 will be
cruising down the city tonight !!
Anyways Thanks for reading !
See you guys again tomorrow .