SteppIR에서 취급하는 1KW Solid State Fully Automatic Linear Amplifier 입니다.

SteppIR사 MonstIR이나 BigIR을 지켜보고 있는데, 이제는 튜너까지 판매를 하고 있군요. 이 튜너를 만든 회사는 이탈리아의 SPE사로 SteppIR 이 미국 판매권을 획득해 팔고 있습니다. 국내에도 수입이 될 지 모르겠습니다.   여러 OM님, 이 튜너가 어떨지 말씀해 주시면 고맙겠습니다. 관련 페이지는  <A href="http://www.steppir.com/SteppirSPE.html">http://www.steppir.com/SteppirSPE.html</A> 입니다.   모델명 : SPE EXPERT 1K-FA   <A href="http://www.steppir.com/files/Expert1K-FA-FrontPanel.jpg"> <IMG style="WIDTH: 389px; HEIGHT: 265px" height=281 src="https://img1.daumcdn.net/relay/cafe/original/?fname=http%3A%2F%2Fwww.steppir.com%2Fimages%2FExpert1K-FA-FrontPanel-small.jpg" width=500 border=0></A>  전면부 사진 <A title="DB36 at N9ADG" href="http://www.steppir.com/files/Expert1K-FA-RearPanel.jpg"> <IMG height=221 src="https://img1.daumcdn.net/relay/cafe/original/?fname=http%3A%2F%2Fwww.steppir.com%2Fimages%2FExpert1K-FA-RearPanel-small.jpg" width=392 border=0></A>  후면부 사진   <DIV>-  The smallest in the world</DIV> <DIV>       Built–in Power Supply and Automatic Antenna Tuner</DIV> <DIV>       Dimensions:  W 28, H 14, D 32 cm (W 11.02”, H 5.51”, D 12.60”) (connectors included)</DIV> <DIV>       Weight: approx.  20 Kg  (19 Kg typ.), 44 lbs (41.8 lbs typ.).</DIV> <DIV> </DIV> <DIV>-  The most technologically advanced in the world</DIV> <DIV>       Two CPUs are used, one of which is dedicated to the transceiver interface requirements (CAT).</DIV> <DIV>       Pi-L output circuit.</DIV> <DIV>       Over 13000 lines of software for performance that cannot be found in any other amplifier.</DIV> <DIV> </DIV> <DIV>-  Fully Automatic</DIV> <DIV>       Easy connection with all models "ICOM, YAESU, KENWOOD, TEN-TEC, FlexRadio ELECRAFT" for immediate</DIV> <DIV>        management of the bands, tuner and antennas.</DIV> <DIV>       Same performance with all makes or homemade rigs.</DIV> <DIV>       The operator has only to move the “Frequency Tuning Knob” in the transceiver!!!</DIV> <DIV> </DIV> <DIV>-  Wide frequency coverage</DIV> <DIV>       1.8 MHz to 50 MHz including WARC Bands.</DIV> <DIV> </DIV> <DIV>-  Full solid state</DIV> <DIV>       1 KW pep SSB out.; 900 W pep CW out (typ.) ; 700 W pep out. (typ.) on </DIV> <DIV>       50 MHz.</DIV> <DIV>       FULL / HALF power selected according to the operator SSB/CW power requirement, for digital modes</DIV> <DIV>            and for linear protection (automatic).</DIV> <DIV>       No heating time, immediately ready!</DIV> <DIV>       Virtually limitless life of the amplification devices (MOSFETs)!</DIV> <DIV> </DIV> <DIV>-  Automatic Antenna Tuner built-in</DIV> <DIV>       Capable of matching 3:1 SWR on HF, and 2.5:1 SWR on 6 meters.</DIV> <DIV>       Capable of programmable switching of 4 antennas (SO239 connectors).  </DIV> <DIV>       Up to two antennas for the same band.</DIV> <DIV>       Bands, Antennas, Tuning conditions are changed in 10 msec.</DIV> <DIV>       Bands, Antennas and Tuning conditions are managed also in “STANDBY“ to support the exciter only.</DIV> <DIV> </DIV> <DIV>-  SO2R </DIV> <DIV> </DIV> <DIV>-  Two  inputs available</DIV> <DIV>       SO239 connectors.</DIV> <DIV> </DIV> <DIV>-  High power gain (16 dB)</DIV> <DIV>       In “OPERATE“ the required drive power is automatically set with an ALC connection.</DIV> <DIV>       In “STANDBY“ the exciter is automatically reset to full power.</DIV> <DIV> </DIV> <DIV>-  Very clean and low distortion output</DIV> <DIV>       Spurious emissions less than -50 dB ( 50 MHz –60 dB ).</DIV> <DIV>       3rd order distortion (two tone test) 36 dB typ.</DIV> <DIV> </DIV> <DIV>-  Input 50 ohm always perfectly matched</DIV> <DIV>       SWR less than 1.2:1.</DIV> <DIV> </DIV> <DIV>-  Fully protected</DIV> <DIV>       Temperature, Over Voltage, Over Current, SWR, Reflected Power, Max RF Tuner Voltage, Over Drive, Amp. </DIV> <DIV>       The correct parameters are continuously monitored.</DIV> <DIV>       The same protections are realized in two different ways:</DIV> <DIV>              - Via hardware circuits  (HW) to assure great spee.</DIV> <DIV>         - Via the software (SW), to assure great accuracy.</DIV> <DIV>       Thanks to the SW, transmit relay changeover is carried out with zero current at the contacts.</DIV> <DIV> </DIV> <DIV>-  Full break-in operation (QSK)</DIV> <DIV> </DIV> <DIV>-  Normal / Contest operation to optimize the performance</DIV> <DIV> </DIV> <DIV>-  Very quiet operation</DIV> <DIV>       Seven quiet three-speed cooling fans:</DIV> <DIV>        · 150 CFM maximum total air flow.</DIV> <DIV>       Temperature thresholds for speed change:</DIV> <DIV>        · 65 °C (149 °F). and 75 °C (167 °F). (normal mode).</DIV> <DIV>        · 60 °C (140 *F). and 70 °C (158 °F). (contest mode).</DIV> <DIV> </DIV> <DIV>       Noise level: </DIV> <DIV>        · 39 dBa at maximum blower speed.</DIV> <DIV> </DIV> <DIV>-  Continuous use</DIV> <DIV>       "FULL" mode: SSB unlimited,   Key down 2 minutes.</DIV> <DIV>       "HALF" mode: SSB unlimited,   Key down 5 minutes.</DIV> <DIV> </DIV> <DIV>-  Regulated power supply,  input 230 / 215 / 200 / 115 / 100 Vac</DIV> <DIV>       With all input voltages the out power doesn't change.</DIV> <DIV>       A well designed grain-oriented, tape-wound toroidal transformer reduces magnetic fields around the amplifier.</DIV> <DIV>      Current draw, typical in  "FULL" mode:</DIV> <DIV>            230 Vac = 10A,   115 Vac = 20A</DIV> <DIV> </DIV> <DIV>-  The linear can be switched ON / OFF also switching  ON / OFF the exciter</DIV> <DIV> </DIV> <DIV>-  With a large LCD display is possible to have a great deal of information</DIV> <DIV>       W pep out, V pa, I pa, W pep reflected, Power gain, Temperature (°C, °F), SWR,  Input setting, CAT setting, Band and other</DIV> <DIV>       indications including an alarms log.</DIV> <DIV> </DIV> <DIV>-  Easy to operate</DIV> <DIV>       Powerful software gives you a user-friendly unity.</DIV> <DIV> </DIV> <DIV>-  RS 232 port for a PC control</DIV> <DIV>       Software is supplied to remote the linear front panel.</DIV> <DIV>       With a proper protocol it is possible to use this port not only as a remote control but also as a CAT port (useful to link the linear</DIV> <DIV>        with any customer application).</DIV> <DIV> </DIV> <DIV>-  Easy transportation</DIV> <DIV>       A sturdy carry-bag is supplied for “QSY, FIELD DAY, DX’ PEDITIONS etc.“.  </DIV> <DIV> </DIV> <DIV>-  Certifications :</DIV> <DIV>               CE , FCC  </DIV>   <DIV class=wpmd> <DIV>Introductory price of $3849.00 USD, Plus shipping and handling.</DIV></DIV>

카페정보

수퍼 XQ 안테나

브론즈 (공개)
카페지기 HL1SAK
회원수 856
방문수0
카페앱수4

카페 전체 메뉴

▲

카페 게시글

tuner SteppIR에서 취급하는 1KW Solid State Fully Automatic Linear Amplifier 입니다.

DS1RZD 추천 0 조회 180 09.06.09 16:26 댓글 2

게시글 본문내용

다음검색

저작자 표시 컨텐츠변경 비영리

HL2SAK
09.06.09 20:03

첫댓글 현시가로 거의 600만원이 홋가 하네요. 오토메텍 튜너가 내장 돼있긴 하지만 직접 증폭 방식의 리니어가 주같읍니다.솔리드 타입이 되니 50Mhz까지 증폭은 되나 최고의 성능을 발휘하여 만족을 준다 해도 고급앰프와 튜너를 합친것보다 비경제적이 아닐까? 생각해봅니다.
hl5bsx
09.06.09 22:58

가격이..ㅎㅎ 전...별로...