|
공정 1일차 - 자재입고 및 검수, 토대설치, 벽체 조립 희망찬 동해의 태양을 안고 하루를 시작합니다.
▲ 팀원회의(작업 진행과정 설명외)
▲ 자재입고(팀원, 작업동선고려), 검수
▲ 부자재 정리(종류별, 크기별 분류)
▲ 공구함 개방
▲ 토대설치 및 레이아웃 ▲ 관련근거 R403.1.6 Foundation anchorage. Sill plates and walls supported directly on continuous foundations shall be anchored to the foundation in accordance with this section. Wood sole plates at all exterior walls on monolithic slabs, wood sole plates of braced wall panels at building interiors on monolithic slabs and all wood sill plates shall be anchored to the foundation with anchor bolts spaced a maximum of 6 feet (1829 mm) on center. Bolts shall be at least 1/2 inch (12.7 mm) in diameter and shall extend a minimum of 7 inches (178 mm) into concrete or grouted cells of concrete masonry units. A nut and washer shall be tightened on each anchor bolt. There shall be a minimum of two bolts per plate section with one bolt located not more than 12 inches (305 mm) or less than seven bolt diameters from each end of the plate section. Interior bearing wall sole plates on monolithic slab foundation that are not part of a braced wall panel shall be positively anchored with approved fasteners. Sill plates and sole plates shall be protected against decay and termites where required by Sections R317 andR318. Cold-formed steel framing systems shall be fastened to wood sill plates or anchored directly to the foundation as required in Section R505.3.1 orR603.3.1. 외.
▲ 벽체조립 ▲ 고려사항 TABLE R602.3(1) FASTENER SCHEDULE FOR STRUCTURAL MEMBERS
▲ 탑플레이트 이음
▲ 코너 우레탄폼 충진
▲ 더블탑 플레이트 설치(안전고려)
▲ 기준벽체 설치 완료. |