|
Bowline | |
---|---|
Names | Bowline, boling knot (archaic) |
Category | Loop |
Origin | Ancient |
Related | Sheet bend, double bowline, water bowline, Yosemite bowline, Spanish bowline, Portuguese bowline, triple bowline, bowline on a bight, running bowline, poldo tackle, Eskimo bowline, cowboy bowline |
Releasing | Non-jamming |
Typical use | Making a fixed loop in the end of a line |
Caveat | While widely considered a reliable knot, when tied in certain materials or loading conditions it may not hold. |
ABoK | #1010, #1716 |
Instructions | [1] |
The bowline (/ˈboʊlɪn/ or /ˈboʊlaɪn/)[1] is an ancient and simple knot used to form a fixed loop at the end of a rope. It has the virtues of being both easy to tie and untie; most notably, it is easy to untie after being subjected to a load. The bowline is sometimes referred as King of the knots because of its importance. It is one of the four basic maritime knots (the other three are figure-eight knot, reef knot and clove hitch).
The structure of the bowline is identical to that of the sheet bend, except the bowline forms a loop in one rope and the sheet bend joins two ropes. Along with the sheet bend and the clove hitch, the bowline is often considered one of the most essential knots.[2]
Although generally considered a reliable knot, its main deficiencies are a tendency to work loose when not under load, to slip when pulled sideways[3] and the bight portion of the knot to capsize in certain circumstances.[citation needed] To address these shortcomings, a number of more secure variations of the bowline have been developed for use in safety-critical applications.
The bowline's name has an earlier meaning, dating to the age of sail. On a square-rigged ship, a bowline (sometimes spelled as two words, bow line) is a rope that holds the edge of a square sail towards the bow of the ship and into the wind, preventing it from being taken aback.[4] A ship is said to be on a "taut bowline" when these lines are made as taut as possible in order to sail close-hauled to the wind.[5]
The bowline knot is thought to have been first mentioned in John Smith's 1691 work A Sea Grammar under the name Boling knot. Smith considered the knot to be strong and secure, saying, "The Boling knot is also so firmly made and fastened by the bridles into the cringles of the sails, they will break, or the sail split before it will slip."[6][7]
Another possible finding was discovered on the rigging of the Ancient Egyptian Pharaoh Khufu's solar ship during an excavation in 1954.[8]
The bowline is used to make a loop at one end of a line. It is tied with the rope's working end also known as the "tail" or "end". The loop may pass around or through an object during the making of the knot. The knot tightens when loaded at (pulled by) the standing part of the line.
The bowline is commonly used in sailing small craft, for example to fasten a halyard to the head of a sail or to tie a jib sheet to a clew of a jib. The bowline is well known as a rescue knot for such purposes as rescuing people who might have fallen down a hole, or off a cliff onto a ledge. They would put it around themselves and sit on the loop. This makes it easy to heft them up away from danger. The Federal Aviation Administration recommends the bowline knot for tying down light aircraft.[9]
A rope with a bowline retains approximately 2/3 of its strength, with variances depending upon the nature of the rope,[10] as in practice the exact strength depends on a variety of factors.
In the United Kingdom, the knot is listed as part of the training objectives for the Qualified Firefighter Assessment.[11]
A mnemonic used to teach the tying of the bowline is to imagine the end of the rope as a rabbit, and where the knot will begin on the standing part, a tree trunk. First a loop is made near the end of the rope, which will act as the rabbit's hole. Then the "rabbit" comes up the hole, goes round the tree right to left, then back down the hole. This can be taught to children with the rhyme: "Up through the rabbit hole, round the big tree; down through the rabbit hole and off goes he." An alternative "lightning method" can also be used; see this animation.
There is a potential with beginners to tie what is known as an Eskimo bowline. This faulty knot stems from an incorrect first step while tying the rabbit hole. If the loop is made backwards so that the end of the rope (the bitter end) is on the bottom, the resulting knot will be sideways. The final loop of a sideways bowline will slip[citation needed]. This makes it particularly dangerous[citation needed] in the case of an inexperienced sailor, who, in addition to having an insecure knot, is also less familiar with what to do should it come untied on the water.
As noted above, the simplicity of the bowline makes it a good knot for a general purpose end-of-line loop. However, in situations that require additional security, several variants have been developed:
The round turn bowline is made by the addition of an extra turn in the formation of the "rabbit hole" before the working end is threaded through.
Similar to the double bowline, the water bowline is made by forming a clove hitch before the working end is threaded through. It is said to be stronger and also more resistant to jamming than the other variations, especially when wet.
In this variation the knot's working end is taken round the loop in the direction of the original round turn, then threaded back up through the original round turn before the knot is drawn tight. The Yosemite bowline is often used in climbing.
The cowboy bowline (also called "Dutch bowline"), French bowline, and Portuguese bowline are variations of the bowline, each of which makes one loop. (Names of knots are mostly traditional and may not reflect their origins.) A running bowline can be used to make a noose which draws tighter as tension is placed on the standing part of the rope. The Birmingham bowline has two loops; the working part is passed twice around the standing part (the "rabbit" makes two trips out of the hole and around the tree). Other two-loop bowline knots include the Spanish bowline and the bowline on the bight; these can be tied in the middle of a rope without access to the ends. A triple bowline is used to make three loops.
...as well as a curiously intricate knot on a piece of rigging that appeared to be basically akin to a bowline knot.