KEB Combivert Manual,Error Assistance,COMBIVERT error messages

[한국기술서비스]

KEB Combivert Manual,Error Assistance,COMBIVERT error messages

KEB Combivert Manual

Error Assistance

At KEB COMBIVERT error messages

noP 0 No Operation: control release not activated, modulation switched off, output voltage = 0, drive not guided
E.OP 1 Over Potentional, dc-bus voltage too high
E.UP 2 Under Potentional, dc-bus voltage too low
E.OC 4 Over Current, output current > 2 * Irated (constant torque)
E.OH 8 Over Heat, overheating of the inverter
E.dOH 9 Drive Over Heat, temperature monitoring of the motor was triggered and the delay time has run out
E.LSF 15 Ladeshunt Fault, ladeshunt not connected
E.OL 16 Over Load, overload monitoring of the inverter was triggered
E.nOL 17 No Over Load, cooling period E.OL has run out, error can be reset
E.EF 31 External Fault, error message through external unit A hardware error occurs if E.EF is not programmed .Measure: Send unit to the repair service
E.nOH 36 No Over Heat, overtemperature error is no longer present (E.OH
or E.dOH), error can be reset
E.SEt 39 Set selection error
E.PuC 49 Power circuit identity invalid
FAcc 64 Forward Acceleration: drive accelerated forward
FdEC 65 Forward Deceleration: drive decelerates forward
rcon 69 Reverse Constant: drive runs with constant speed in reverse
LS 70 Low Speed: Control release is activated, no direction of rotation is preset, modulation is switched off, output voltage = 0, drive is not
guided
SLL 71 Stall function is active
LAS 72 LA - Stop is active (acceleration ramp stopped)
LdS 73 LD - Stop is active (deceleration ramp stopped)
SSF 74 Speed - Search - function is active
dcb 75 DC - braking is active
bbl 76 Base - Block time runs out, d.c. to a.c. switched off
dLS 77 Low Speed according to DC - braking