경매번역카페 무료번역질문:
1. Unit conversion for wind load is wrong. And if wind pressure is used in calculation linear wind load should be calculated
based on wall height and the load should be applied at the top of wall
2 Wall : Contractor proposed that place concrete up to 4 m and place 2nd layer after lower layer is set. it is very hard to
perform surface preparation at the joint in the form and it may cause cold joint formation. Even if construction joint is
provided in accordance spec. para. 3.8.1 , location of construction joint shall be verified by profession engineer to show it
does not impair structural integrity.
경매번역 http://cafe.daum.net/transauction