e64 645ci 차량에도 ONE-Touch로 탑의 개폐가 가능하도록 하는 모듈이라고 하네요
전에 XXX샵에 문의를 했는데 장착이 안된다고 했는디...... SmartTOP E93 V1.2X 라고 하네요
1. Start out by putting the top completely DOWN. Next, start closing the top and just when the back lid is all the way open but the roof mechanic has not started to raise yet, stop. 2. Manually move the sliding flap towards the front of the car (1) to reveal another torx screw (2). Remove the screw. 3.Remove another torx screw (1) in the side panel, then lift whole side panel up and out starting in the front (1). The convertible top controller is underneath. 4.The convertible top controller (1) is mounted between the inner and outer wall, right behind the small speaker. In some cases it is mounted upside down inside a metal bracket which is held in place by two screws. 5.Remove the two bolts (1) and (2) holding the white convertible control unit bracket in place. Slide the bracket out to access the plugs shown in the next step. 6.NOW TURN THE IGNITION OFF AND PULL THE KEY OUT! Make sure the convertible top lid is not obstructed as it may sink down slowly once the ignition is off. Move the white lever (1) on the large black plug over to release the plug from it's socket. 7.Release the small latch (1) to remove the plastic covering from the plug. This way the wires and contacts become accessible 8. With a small pick or screw driver remove the following wire contacts from the plug: BROWN-PURPLE from slot 9, BROWN-RED from slot 10, BLACK from slot 12 and YELLOW from slot 13. Install the wire contacts from the module wiring harness instead: GREEN in slot 9, BLUE in slot 10, ORANGE in slot 12 and BROWN in slot 13. 9.Attach the supplied yellow power taps onto the thick power wires. Red with grey stripe is +12V and solid brown is ground
10. Now install the original wires into the supplied plastic caps: BROWN-PURPLE in position 1 and BROWN-RED in position 2 as well as BLACK in position 1 and YELLOW in position 2. The positions are marked clearly on the rear end where the wires are inserted. Make sure they latch into place with an audible "click", then push in the locking latches on the sides of the caps. Connect them as shown (2) to the ones from the module's wiring harness. Install the plastic cap on the plug and insert the plug back into the convertible top controller (2). Lastly, connect the power wires (3) and attach the smartTOP module to the black plug on the wiring harness.
11. Wiring Diagram: Make sure all connections are made as shown, BEFORE turning the ignition back on. 12. Turn the ignition on and watch the LED (1) on the module: It must show a constant blinking pattern. See paragraph about InstallAID LED. Last, put everything back together in the reverse order of removal. Done.
|
첫댓글 좋은 정보 감사합니다....^^ 역쉬 웹셔핑의 대가들이십니다. 스마트탑 사에서는 E93 전용을 저렇게 사용할수 있다고 왜 연락을 안 주는지...^^ 다른 분들께 좋은 자료가 되었습니다....다음주에 한대 작업해 보겠습니다 ^^
걍 645ci 차량에 원터치를 넘 장착하고 싶어서요 혹시나 하는 마음에 웹셔핑을 하다가 발견했습니다 *^^* 다음주 언제쯤요??? 한번 작업하는거 봤으면 하는데... *^^* 그리구 10번 작업내용을 빠뜨려서리.. 추가했습니다 작은 도움이 되었으면 합니다 조만간 찾아뵈겠습니다 *^^*
영구님 후기좀 올려주세요 성공했는지요 ???
네 성공했고요. 국내 입고된 제품중 1.2 버젼이후에 제품만 가능하더군요. 테스트용 1.2 버전 한개 남은것으로 장착했습니다. 사이드 밀러 자동접이 기능도 포함되어 있더군요. 확인해 보니 하나 남은 재고 버젼1 은 6 시리즈에 적용이 안됩니다. 새로 주문했으니 10일후에 1.3 버젼 ( 최신 버젼 )으로 장착하시면 됩니다 ^^
아 네 감축드립니다 신경써줘써 감솨합니다 *^^*
형 원터치라 함은 어떤 거지요? 제껀 계속 누르고 있음 되던데.. 그냥 한 번만 눌러두 열리는 건가요? 닫을때두 원터치루 되나요? ^^; 너무 모르는게 많은 개미입니다 ;;
말그대로 1초의 터치로 탑의 개폐가 가능하도록 하는거 328 335는 원터치로 작동하는걸 봤는데 무척이나 편리하더라구 우리 소프트탑두 된다구 해서리외국싸이트에서...올린거야
저속 주행중에도 오픈되겠죠??
아직 장착을 하지 못했구요 아마도 저속에서 탑의 개폐가 가능한걸로 알고있습니다
20~40 킬로까지 셋팅 가능하더군요
아 네 그렇군요 감솨합니다 영구님 *^^*
제645에도 설치했음 하는데 가능 할까요????
영x샵에서 장착가능한걸로 알고있습니다만... 가격땜시 장착을 못햇습니다 . 일단 한번 연락을 주세요